Quality system The quality of our products is borne out by: • Traceability of each single coil used through Material Certificates drawn up according to the provisions of the EN 10204 Type 3.1 standard • Dimensional reports attesting to compliance of significant product specifications to standard statistical control indices such as Cp – Cpk Pp – Ppk – Cm – Cmk. The highly-refined Quality Management System is based on the ISO/TS 16949 international standard, which was specially developed for the producers of OEM or aftermarket components for the AUTOMOTIVE market. Our commitment to the seal industry has enabled us to: • further the development of a quality management system that targets constant improvement, prioritizing the prevention of defects and the reduction of rejects in the supply chain. • establish strict, common quality system requirements relating to the automotive industry • acquire global external supplier confidence in quality • implement common, internationally-consistent Part III Certification policies and procedures • introduce a process based on checks aimed at customer satisfaction • acquire recognition of the IATF-backed international standard replacing all national certifications                                       Mollificio R.M.I. Via Battitori n.9 (area industriale) Macello (TO) Contatti Tel. (+39) 0121.339038 Fax (+39) 0121.339039 Email info@mollificiormi.it C.F. - P.IVA - N. ISCRIZIONE REG.IMPRESE DI TORINO : 06766740010 Capitale sociale : 52.000 Euro Interamente Versato 2011 copyright | privacy | note legali